Camco Camper/RV Stove Top Cover | Features Adjustable Legs & Built-In Juice Groove | Crafted of Natural Bamboo | Fits Most Stove Tops & Measures 29.5” (L) x 21.25” (W) x 2.5” (H w/feet) (43548)

. Just wanted to write a review to specifically address the review that said you can’t use the legs because the screws don’t fit, because I bought this board over a similar cheaper model available here on Amazon specifically because of the legs and that review made me hesitate, because there were not really any other reviews at the time. Only two even now. The screws, and the legs, are fine. I can however see why they may have thought the screws wouldn’t fit. The legs are in two pieces. The main piece that goes against the board is a hard plastic. A softer nub with some grip then goes between that and the stove. A machine screw goes through both parts. At first it seems the screws are too short. That is because the soft piece has a recessed pocket that you need to push the screw head down into (so it won’t scratch your stove). This makes the screw stick out through the other piece enough that it is then long enough. It is pretty obvious, and even if it were not, there are instructions in the bag that illustrate this exactly. With that said, the legs are a little longer than I would like. It is too bad their height isn’t adjustable in some way. With the legs installed, the wooden legs of the board float about half an inch above the work surface. This gives it a clearance of 1.75 inches between the surface it is sitting on and the underside of the board.As for the board itself. It is very nice, very solid. The rubber feet make it very solid and keep it from sliding around. It was a bit more than I wanted to pay, but I have no complaints. We are considering buying a second, but we are trying to decide if we should get another two burner and use them together when we want to cover all four burners, or get a four burner and swap them out. This is only because we have a counter top range that has a downdraft vent and controls down the center of the range so if we had two two burner versions they would be separated by about a 6 inch gap.I noticed with the four burner though, the wooden legs are only on one side. We are not sure how that would look with a counter top range. With the four burner, the long legs would actual be an advantage, because it is what would allow the board to have the elevation to clear the vent and the controls.Update (Four burner Version)After having the two burner version for a while, we really liked it. When you need to use all four burners, we like to sit it on the side of the range and it makes a nice workspace just sitting there to hold your ingredients, cooking utensils, etc., so even when you are cooking it isn’t really in the way.After using it for awhile we also decided to get the four burner version to provide an even larger workspace when the range was not being used at all.It is amazing how well packed these are for shipping. The size of the four burner version is just about perfect for our range. The adjustable legs allow you to position them just right to make the board nice and stable. In our counter limited kitchen, it is amazing how much extra usable workspace it gives.With that said though, the four burner version is not as nice as the two burner version. The board, despite how well packed it was, is bowed. As another reviewer pointed out, this is nothing more than a cutting board with legs. The two burner version was made to stand on the two wooden legs but the four burner version is a cutting board intended to sit flat on a counter. Maybe it’s because of its larger size, but after just a couple of days, the board is noticeably bowed. It is only half an inch thick and I think expecting a half inch board to be 22″ x 29″ with no support on the edges without bowing is asking too much. A couple edge pieces on the side just like the one on the front would have prevented this problem. The four burner version that we got was also missing one of the four nuts that are used to mount the legs to the board. It looked like they had assembled the legs when they packaged them. One of them was not assembled inside the bag, probably because it came apart inside the bag because the nut was missing, and the nut was not in the sealed bag. I have temporarily borrowed one of the nuts from the two burner version and will try to pick one up at Lowes or Home Depot. Despite not being as happy with it as I was with the two burner version, we still really like it. The extra space is exactly what we needed. Hopefully the bow won’t get any worse. If it does, I might try to see if I can do something to address it. As this is really little more than a cutting board with legs on it, I think if I were to do it again, I would buy a thicker piece of 30″ x 22″ butcher block and just attach legs to it. I actually would probably buy two 15″x22″ butcher blocks and put legs on them as they would be able to cover our whole range like the four burner version does, but you could use one at a time like the two burner version. A 1″ thick piece of butcher block would cost about twice what this did though, so I still think this is not a bad value for what it is.Again, I have the same comment on the legs as I had for the two burner version. They are a little bit taller than we need. Not really a problem, but it would have been nice if their height was adjustable in some way so you could customize their height just like you can customize their position.Since this review is shown for both the 4 burner and 2 burner versions, I am going to leave it at 4 stars, but I would say the two burner version is 4 stars, the four burner version is more like 3. I would easily recommend the two burner version and would probably buy it again. The four burner version needs to be thicker or have more support or something, but for what it is, it actually isn’t a bad value.

. I purchased a brand new gas range to replace an electric range and have been waiting to be able to purchase a noodle board for it! Let me just say, I had never even heard the word noodle board until a couple years ago, and was like what in the world is that? Now, I’m fully aware and think these things are nothing short of genius!! While I hated having an electric range, I did love having that flat surface to put things on. That being said, nothing beats having a gas range, in my humble opinion. I was in love with my new gas range as soon as it was installed, but found myself subconsciously attempting to place things on it as I entered my kitchen, and was like ok, I need a noodle board STAT!! I decided on this one based on price and the reviews, and lemme tell you, it is AMAZING! It’s beautifully built and very sturdy but not too heavy. It arrived in a couple days and was incredibly well packaged!! I inspected it closely out of the box and it didn’t have a single defect or flaw! NOTE: The feet for the board are taped to the inside of top piece of the packaging, so make sure u look there before throwing all the packaging away. I measured as best I could ahead of time to make sure it would fit, and prayed to God it would fit once it arrived! IT FIT!! Woo-hoooo!! Another reviewer mentioned she’d purchased a cutting board oil to apply on it (again I say, who knew this stuff even existed LOL) (Caron & Doucet – Cutting Board & Butcher Block Conditioning & Finishing Oil | 100% Plant Based & Vegan, Best for Wood & Bamboo Conditioning & Finishing, Makes Cleaning Wood Easier | Mineral oil FREE) and her pics, with the oil applied were absolutely gorgeous, so I also ordered that oil, and her recommendation was 1000% on point! I purchased an LG Electronics 5.8 cu. ft. Smart Wi-Fi Enabled Fan Convection Gas Single Oven Range with AirFry and EasyClean in Stainless Steel, Model# LRGL5823S. It has 5 total burners with an optional grate for the center burner. I placed the board on the unit, without the feet and it fit perfectly. Once I started inspecting it as it was sitting on my range, I notice the back was sitting slightly lower and at an angle in comparison to the front, so I decided to add a couple of the feet pieces to the back to try and even it out. I’m not gonna lie, the feet placement is tricky based on the design of my range. I think they’re in a good enough position now and they’ve leveled the board out enough that I’m satisfied, but I was definitely a little frustrated trying to figure that part out! It’s just awkward getting them in the right spot on the board and then figuring out how to get them in the right spot in the burner area, cuz u can’t really see anything when doing either of these things. Just something to keep in mind. I also opted to remove my grate so that the board sat flush with the range in the front. Either way worked, it ended up just being a personal preference for me. I am absolutely positively in love with this board and HIGHLY recommend it to anyone in the market for a “noodle board” 🤣 (and don’t forget the oil too!!). The pics are in order of the board on my range with the grate and without the grate, front and side for each option. Last pics are of the feet, just as a visual for reference.

Very happy with it. You have to install the little legs yourself and adjust to fit your stovetop.A good rubbing with some olive oil to seal it brings out the colour nicely.

This product is ideal for creating extra bench space.

. Honestly, I wanted this board cause my cats walk over my stove top and make a mess everyday This bamboo board really fixes this problem ! The over all quality is very good, it really looks nice with our granite counter tops 💚